Bosch MX30E Consignes De Fonctionnement/Sécurité page 11

DM 2610033449 02-14_MX30E 2/11/14 12:54 PM Page 11
NOTE: Speed is affected by voltages
changes. A reduced incoming voltage will
slow the OPM of the tool, especially at the
lowest setting. If your tool appears to be
running slowly, increase the speed setting
accordingly. The tool may not start at the
lowest switch setting in areas where outlet
voltage is less than 120 volts. Simply move
the speed setting to a higher position to
begin operation.
The variable speed control settings are
marked on the speed control dial. The
settings for approximate /min (OPM) are:
Switch Setting
1
2
3
4
5
6
You can refer to the charts on next page to
determine the proper speed, based on the
material and accessory being used. These
charts enable you to select both the correct
accessory and the optimum speed at a glance.
-11-
Speed Range
/min (OPM)
8,000
10,400
12,800
15,200
17,600
20,000