Stihl FS 300 Notice D'emploi page 19

Grass Cutting Blades, Brush Knife,
Shredder Blade
1
3
4
Cutting attachments with 2, 3 or 4 blades
may point in either direction – these
cutting attachments must be turned over
regularly to help avoid one-sided wear.
The cutting edges of the grass cutting
blades 255-8 (2) and 250-40 Spezial (3)
must point clockwise.
N Fit the guard ring for mowing
applications.
FS 300, FS 350, FS 400, FS 450, FS 480
4
2
5
N Place the cutting attachment (1) in
position.
Collar (a) must locate in the
cutting attachment's mounting
hole (b).
The cutting edges of the shredder
blade (2) must point upwards.
N Fit the thrust washer (3) – convex
side must face up.
N
Fit the rider plate (4) (for mowing) or
guard ring (5) (for shredder blade).
N Block the drive shaft.
N Screw on the nut (6)
counterclockwise and tighten it
down firmly.
Remove the tool used to block the
shaft.
6
5
3
2
b
1
a
Removing the cutting attachment
N Block the drive shaft.
N Unscrew the mounting nut
clockwise.
If the mounting nut has become
too loose, fit a new one.
Circular Saw Blades 200 and 225
N Fit the guard ring for saw blades.
4
3
2
b
a
N Place the cutting attachment (1) in
position – the cutting edges must
point clockwise.
Collar (a) must locate in the
cutting attachment's mounting
hole (b).
N Fit the thrust washer (2) – convex
side must face up.
N Fit the rider plate (3) (for saw
blades).
English
1
17