Setting Down And Storing The Vacuum Cleaner - Miele SBAN0 Mode D'emploi

en-US
 Turn the suction power selector man-
ually to the suction power setting you
require.
Opening the air inlet valve (Fig. 19)
It is easy to reduce the suction power
for a short time, e.g., to prevent rugs or
other objects being sucked into the
vacuum cleaner.
 Open the air inlet valve on the handle
far enough to reduce the suction
power.
The floorhead will be easier to maneu-
ver.
Setting down and storing the
vacuum cleaner
Park system for pauses during vacu-
uming (Fig. 20)
The park system allows you to conve-
niently park the suction wand and floor-
head during pauses.
 Slot the floorhead into the parking at-
tachment on the vacuum cleaner.
If your vacuum cleaner is on a slop-
ing surface, e.g., a ramp:
– Retract the telescopic suction
wand fully.
– Do not use the park system if your
vacuum cleaner has an EasyLock
suction wand.
18
Park system for storage
(Figs. 21 + 22)
Risk of electric shock from volt-

age.
The supply voltage is applied to the
appliance even if it is switched off.
After use, unplug the appliance from
the electrical socket.
 Stand the vacuum cleaner upright.
If your vacuum cleaner has a tele-
scopic suction wand, retract the parts
fully so that it takes up less room for
storage.
 Slot the floorhead downwards into
the parking attachment.
If your vacuum cleaner has an Easy-
Lock suction wand, you can detach this
so that the vacuum cleaner requires
less storage space.
 Press the release button on the lower
suction wand section and pull the top
section out.
 Push the connection piece attached
to the upper suction wand section
into the lower section.