Hewlett Packard e-Vectra Guide D'utilisation Rapide page 28

Federal Communications Commission Radio Frequency Interference Statement
Warning:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to correct the interference by
one or more of the following measures:
• reorient or relocate the receiving antenna
• increase the separation between the equipment and the receiver
• connect the equipment into an outlet on a circuit different from that to which the receiver is connected
• consult the dealer or an experienced radio/TV technician for help.
Hewlett-Packard's FCC Compliance Tests were conducted with HP-supported peripheral devices and HP
shielded cables, such as those you receive with your system. Changes or modifications not expressly
approved by Hewlett-Packard could void the user's authority to operate the equipment.
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la Class B est conforme à la norme NMB-003 du Canada.
If the power cord is not supplied with the e-Vectra, select a power cord in accordance with your national
electrical specifications.
USA: use a UL listed type SVT detachable power cord.
Canada: use a CSA certified detachable power cord.
For your safety, never remove the e-Vectra's cover without first removing the power cord from the power
outlet and any connection to a telecommunications network. Always replace the cover before switching
the e-Vectra on again
(If lithium battery is used)
There is a danger of explosion if the battery is incorrectly installed. For your safety, never attempt to
recharge, disassemble, or burn an old battery. Only replace the battery with the same or equivalent type,
as recommended by the manufacturer. The battery in this e-Vectra is a lithium battery which does not
contain any heavy metals. Nevertheless, in order to protect the environment, do not dispose of batteries in
household waste. Please return used batteries either to the shop from which you bought them, to the
dealer from whom you purchased your e-Vectra, or to HP so that they can either be recycled or disposed
of in the correct way. Returned batteries will be accepted free of charge.
Si le cordon secteur n'est pas livré avec votre ordinateur, utiliser un cordon secteur en accord avec votre
code electrique national.
Canada : utilisez un cordon secteur certifié CSA.
Pour votre securité, n'enlevez pas le capot de cet équipement avant d'avoir débranché le cordon secteur et
toute connexion au réseau de télecommunications. Remettez toujours le capot avant de mettre
l'équipement sous tension
(En cas d'utilisation de pile au lithium)
Il y a danger d'explosion lorsque la pile n'est pas installée correctement. Pour votre sécurité, n'essayez
jamais de recharger, démonter ou brûler la pile usagée. Remplacez-la uniquement avec une pile du même
type ou d'un type équivalent recommandé par le constructeur. La pile dans ce e-Vectra est une pile au
lithium ne contenant pas de métaux lourds, néanmoins, afin de protéger l'environement, ne jetez pas les
piles dans les ordures ménagères. Rendez-les où vous les avez achetées, au distributeur à qui vous avez
acheté votre e-Vectra ou à Hewlett Packard, pourqu'elles soient recyclées ou jetées de manière qui ne nuit
pas à l'environnement. Les piles usagées seront acceptées gratuitement.