Video Matrix Ks Vm 164; Connection; Video Device Setup - EverFocus KS-KBK Manuel D'instructions

5.5 Video ma trix KS VM 164

5.5.1 Connection

5.5.1.1 Cable
The communication cable is standard, as described in § Standard connection cable, page 8.
5.5.1.2 Matrix settings
The matrix KS VM 164 can be controlled by different types of keyboard and therefore emulates the respective
protocols: to control the switcher with the KS KBK keyboard the MACRO protocol with baud rate 38400 should
be used.
Set the dip switches in the matrix as required (all dips are OFF, with the exception of Macro Protocol, baud rate
38400, programming).
5.5.1.3 Keyboard set tings
While the keyboard is being set up, the
follows:




The presence of a maximum of four keyboards connected to the matrix means it is necessary to define a
different identification number for each one (from 1 to 4).
5.5.1.4 Operational t est
If the keyboard is connected directly with the switcher set up in this way using the telephone cable supplied, it
should be possible to switch the input videos immediately:

• press

• press
5.5.2 Video devic e setup
The setup procedure is described in the video device's instruction manual.

Press to enter setup, and insert setup password if it has been enabled.

Control of a KS VM 164 matrix
to select monitor 1

, , to select the cameras.
Page 21
submenu should be set as
MNECKSKBK_0350