Views - EverFocus KS-KBK Manuel D'instructions

5.2.4 "Views"

Views can be used to carry out a series of four operations by pressing only one key:
• selection of a new active monitor
• selection of a camera on the new active monitor
If the views are set up correctly this will speed up operations by making 10 preset camera/monitor operations
available to the operator.
The use of views is especially useful in alarm situations: if key
3, just pressing key
                           
By pressing the key the operator will therefore be able to quickly recall a preset position defined on a monitor.
5.2.4.1 Defining the v iews
Views are set up by pressing three keys simultaneously, from
operator is authorised to set up the views.
The display shows the current setup of the view for about one second, and then passes to the request for new
parameters:










5.2.4.2 Requesting th e views

Press a key from
5.2.4.3 Erasing the c ustomised views

Press keys
The default settings for the views can be used to recall cameras 1 to 9 directly without changing the active
monitor and without making scans. The

will replace the sequence

to to request the corresponding view.
simultaneously.



The display in the example illustrated here shows that when key
1 is pressed, this is a request for camera 1 on the active monitor
(the symbol means that no monitor in particular is requested for

the operation).
Inserting the camera.
Insert a number or press
number.
Inserting the monitor.
Insert a number or press
number. If the number 0 is inserted this means the active monitor
will not be changed when the view is requested.
recalls camera 10.
Page 18
is associated with camera 12 and monitor

to

to confirm the previously defined

to confirm the previously defined
, if the
MNECKSKBK_0350