Hitachi C 10RA2 Mode D'emploi page 16

English
Down
Up
Wheel
Fig. 15-a
Fig. 15-b
3. Adjustment of rip fence
Support
Front Rail
Fig. 16-a
Miter Gauge
Groove
Grip
Fig. 16-b
16
r If the saw blade is not at a left bevel 45°, loosen the saw
Saw Blade
Loosen
t After adjustment, tighten the saw blade tilt lock handle.
Tilt Lock
Tighten y On completion of adjustment, recheck the left 45° bevel of
Handle
Saw Blade
45° Gauge
Before shipment from the factory the saw blade is set parallel to
Rip Fence
the miter gauge groove and the rip fence is adjusted parallel to
the miter gauge groove. Check and adjust the parallel of the rip
fence by the following procedures. In order to accurate work and
prevent kickback when ripping. Before adjustment of rip fence,
check and adjust slider (It is assembled under the width body.) to
engage with the groove on front rail.
(1) Raise the grip to the upside and release the fixation of the rip
fence (see Fig. 16-a).
(2) Position the rip fence at one edge of the miter gauge groove.
(3) Lower the grip to the bottom and fix the rip fence. The edge
of the rip fence should line up parallel with the miter gauge
Grip
groove.
(4) If the edge of the rip fence is not parallel with the miter gauge
groove.
Parallel Bracket
q Loosen the four 6 mm hex. hd. bolts securing the parallel
w Raise the grip to the upside and release the fixation of the
e While holding the parallel bracket to prevent movement,
6 mm Hex. Hd. Bolt
r Raise the grip to the upside and release the fixation of the
Width Body
t Repeat adjustment until it is parallel.
y After adjustment, tighten four 6 mm hex. hd. bolts.
u On completion of adjustment, recheck the rip fence is
blade tilt lock handle. Loosen the 6mm machine screw (B)
(see Fig. 13-c) a few turns and move the saw blade tilting
mechanism until the blade is at left bevel 45° to the table
(see Fig. 15-b).
the saw blade and table.
bracket to the width body and support.
rip fence.
Align the rip fence parallel to the miter gauge groove.
Lower the grip to the bottom and fix the rip fence.
tighten the four 6 mm hex. hd. bolts previously loosened
(see Fig. 16-b).
rip fence. Move and return the parallel bracket adjacent to
the miter gauge groove. Lower the grip to the bottom and
fix the rip fence. And verify that the parallel bracket is
parallel to the miter gauge groove.
parallel with the miter gauge groove.