Height Adjustment; Care And Maintenance - Joie roomie glide Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 19
Bedside Sleeper Assembly
see images
-
1
26
Please read all the instructions in this manual before setting up and using this product.
!
Please make sure that the adjustable side rail faces in the same direction with adjustable feet.
Rocking Function Activation
see images
-
27
28
!
Please lock the rocking function during using the unit as bedside sleeper.

Height Adjustment

see images
-
29
32
!
The crib can be adjusted to different height positions.
!
The crib can be inclined with a maximum variance of 4 positions between one leg and the other (for
example: the right leg in position 5 and the left leg in position 1, see fig.
!
It only be applicable to cradle state, but not to bedside sleeper state.
!
The head of the child should always be positioned on the highest side.
Use Wheels
see images
-
33
34
At this point the crib is ready to be used.
!
Do not use the crib with adjustable feet partially or totally rotated and unlocked. The correct position for use
is illustrated in figure
26
. In the case of accidental knocks against adjustable feet, return them to the correct
position by lifting the crib slightly.
Use Bedside Sleeper
see images
-
35
44
-
35
35
1.Press the button
1
to drop the side down
2.Position next to bed
36
, Connect Buckle to roomie glide
39
40
to adjuster buckle
, then pull straps tight
.
!
During fixing the crib to the parent's bed, If it is not possible to slide the feet of the crib under the parent's
37
bed, you can rotate the adjustable feet.
3.Ensure no gap between parent's mattress and roomie glide
parents' mattress and the drop side at the lowest position is 2cm
4.The type of adult bed which can be used with bedside sleeper is slatted bed frame and box / divan bed
frame, the dimensions of adult bed shown on fig.
!
Check to make sure that the crib in the bedside sleeper mode does not interfere with the parent's bed.
!
During use, make sure that the parents bed sheets, blankets etc. Do not enter and cover the interior of the
crib.
!
In the bedside sleeper mode the 2 legs of the crib should always be adjusted to the same height.
!
Before every use always check to make sure that there is no space between the parent's mattress and the
side of the crib. If there is, pull the belts firmly to tighten until there's no space and the permitted condition of
use has been restored.
17
28
).
31 32
31 32
31 32
-
2.
38
then loop strap around bed frame and connect
41
. The maximum height difference between the
42
43
44
&
!
Use of the product is only permitted with beds and/or mattresses with straight sides. Use of the product with
round beds and/or mattresses or water beds is not permitted.
!
When the product is used in the "bedside sleeper mode" (fixing to the bed, it should always be fitted to the
long side of access to the bed. Do not fix the product to the head or bottom of the bed.
Use Storage Bag
see images
-
45
46
!
Refer to Bedside Sleeper Assembly and perform reverse operation to fold the unit, and use the bag for
convenient transportation.
Accessories (May not be included)
Sheet Assembly
see images
47
!
Prevent possible suffocation or entanglement. NEVER use product sheet unless it fits securely on product
mattress.
!
Wrap the sheet around the mattress on all four corners. MAKE SURE the sheet is securely attached to the
four corners.

Care and Maintenance

see images
-
48
50
1. The fabric cover of crib is not removable.
2. Your product can be spot cleaned with a sponge and soapy water.
3. Do not use undiluted neutral detergent, gasoline or other organic solvent to wash the product. It may cause
damage to the product.
4. To wash carry bag, machine wash in lukewarm water and drip-dry. Do not use bleach.
5. At the beach or in the garden, clean sand and grit off your product. Sand in the long rail locks may cause
damage.
6. From time to time, check your product for worn parts, torn material or stitching. Replace or repair the parts as
needed.
7. If the product is not in use for a long period of time, please put it in the shade where your child cannot access
it.
18

Publicité

Table des Matières
loading

Table des Matières