Permitted Dispersion Tools; Speed Table - IKA T 10 basic ULTRA-TURRAX Mode D'emploi

Permitted dispersion tools

Designation
S 10 N - 5 G
S 10 N - 8 G
S 10 N - 10 G
S 10 D - 7 G - KS - 65
S 10 D - 7 G - KS - 110
Only use the dispersing tools listed in the table and note
the according operating instructions of the dispersion tool.

Speed table

Note: The speed table was calculated on the basis of a dispersion
Material of shank
volume of 5 ml water using the dispersing tool S 10 N - 5 G.
Stainless steel
With other combinations (dispersion tools; medium quantity and
medium viscosity) can result other number of revolutions values.
Stainless steel
Adjusting wheel
scale
No-load speed
Stainless steel
Speed with
5 ml water
Synthetic material
The speeds depend on the dispersing element used as well as the
viscosity and quantity of the medium. Therefore it may change
over the course of a dispersing process if the viscosity of the liquid
Synthetic material
changes.
1 2 3 4
8.000 9.500 11.500 14.500 20.500
7.900 9.400 11.400 14.450 20.450
5 6
30.000
29.900
18