Step 3. Installing The Power Cord - Samsung NE58K9850 Manuel D'utilisation Et D'installation

STEP 3. INSTALLING THE POWER CORD

For power cord installations, hook the strain relief over the power cord hole (1
located below the rear of the drawer body. Insert the power cord through the strain
relief and tighten the device.
Power cord
• You must install the power cord with a strain relief.
• Attach the strain relief to the 1
Installing a 3-wire power cord
WARNING
WARNING
connected to the neutral terminal located in the center of the terminal block. The power
leads must be connected to the lower left and the lower right terminals of the terminal block.
1. Remove the 3 lower terminal screws
from the terminal block.
2. Insert the 3 terminal screws through
each power cord terminal ring and into
the lower terminals of the terminal block.
Be certain that the center wire (white/
neutral) is connected to the center lower
position of the terminal block.
3. Tighten screws securely to the terminal
block. DO NOT remove the ground
strap connection.
4. Go to Step 5 on page 15 to continue
with the installation.
Install_NE58H9970WS_AA_AC_DG68-00594A-05_EN+MES+CFR.indb 10
Conduit connection plate
Strain relief
/ " opening in the conduit connection plate.
3
8
The neutral or ground wire of the power cord must be
English - 10
Neutral
terminal
White
Black
White
Black
/ ")
3
8
Ground strap
Red
Red
2017-08-11 6:28:42