Disposal; Troubleshooting - Philips AVENT SCF358 Mode D'emploi

ENGLISH
16

Disposal

Your product is designed and manufactured with high quality materials and
components, which can be recycled and reused. For recycling information, please
contact your local waste management facilities or visit www.recycle.philips.com.

Troubleshooting

This chapter summarizes the most common problems you could encounter with
the appliance. If you are unable to resolve the problem with the information below,
contact the Consumer Care Center in your country.
Problem After switching on the bottle warmer, the entire progress indicator
blinks fast and switches off.
• The temperature of water in the bottle warmer is too hot or too
Cause
cold.
• The boil-dry protection is activated.
• Switch off and unplug. Let it cool down for a few minutes. Make
Solution
sure you fill it with fresh room temperature water.
• The bottle warmer automatically switches off if it is on and there
is no water or not enough water in it. Switch off and unplug. Let
it cool down first. Make sure you fill it with enough fresh room
temperature water. The bottle warmer is ready to use again.
Problem The milk is too hot.
• You may have selected an incorrect setting or are using a milk bag.
Cause
• Select the milk volume setting based on the milk volume, not the
Solution
bottle size.
• If you are using a milk bag, select the keep warm / defrost setting.
Problem The milk is still cold.
• You may have selected an incorrect setting, are using a silicone
Cause
bottle, or have filled the bottle warmer with warm water.
• Select the milk volume setting based on the milk volume, not the
Solution
bottle size.
• If you are using a silicone bottle, select the milk volume setting
based on the milk volume. When the entire progress indicator is
on, wait for 3-4 minutes for the milk to warm.
• Fill the bottle warmer with fresh room temperature water. Do not
use warm water.