Environmental Protection; Maintenance And Cleaning - Bosch GHG 500-2 Instructions D'emploi

Masquer les pouces

Table Des Matières

Table des Matières

Defrosting Water Pipes

Water lines often do not differ in appear-

ance from gas lines. Gas lines are not to

be heated under any circumstances.

Place on the reflector nozzle 8. Heat the frozen zone

always from the outside to the middle.

Warm plastic pipes as well as connections between

pipe pieces especially carefully to prevent damage.

Soft Soldering

For point soldering, place on the reduction nozzle 11,

for the soldering of pipes, the reflector nozzle 8.

If solder without flux is used, apply soldering grease or

paste to the location to be soldered. Warm the loca-

tion to be soldered for 50–120 s depending on the

material. Apply the solder. The solder must melt from

the work piece temperature.

After the soldered location has cooled, remove the

flux.

Maintenance and Cleaning

Before any work on the machine itself, pull the

power plug.

For safe and efficient working, always keep the ma-

chine and the ventilation slots clean.

WARNING

Important instructions for connecting a new

three-pin plug to the two-wire cable.

The wires in the cable are colored according to the fol-

lowing code:

strain relief

live = brown

neutral = blue

Do not connect the blue or brown wire to the ground

terminal of the plug.

Important: If for any reason the plug is cut off the ca-

ble of this machine, it should be disposed of to prevent

misuse.

If the unit should fail despite the care taken in manu-

facture and testing, the repair should be performed by

an authorized customer services location for Bosch

power tools.

For all correspondence and spare parts orders, always

include the 10-digit order number from the nameplate

of the unit.

1 609 929 F40 • (03.07) T