Chimney Duct; Installing The Range Hood - Arda HM-20100630 Guide D'utilisation

9. attach 6" aluminum duct (not included) to the prepared duct work in the ceiling. Seal
all seams.
Fixing the Decorative

Chimney Duct

1. Carefully separate the telescopic chimney
duct pieces.
2. attach the inner piece of the decorative
chimney to the top of the cage with screws
provided (C).
3. Slide the outer piece of the decorative
chimney on to the cage over the inner chimney
and temporarily hold in place with two screws
(D).

Installing the Range Hood

Please note that to avoid damaging the
hood, installation requires three people.
1. Remove grease filters from range hood.
2. With the assistance of two other people
lifting the hood from below, raise the
unit until the lower cage sits inside the
range hood lower cage. Be sure the unit
is installed with the controls facing front.
Screw hood to cage (E).
3. attach 6" aluminum duct to the hood
duct connector. Seal all seams.
4. Plug in the unit. note: all electrical wiring
must be done by a qualified person and
in accordance with all applicable codes
and standards. This range hood must be
properly grounded.
5. Remove temporary screws holding the lower decorative chimney piece in place.
6. From inside the hood, screw the lower chimney to the range hood.
7. Re-install the grease filters
- 8 -
Island Mounted Hoods
Decorative Chimney
duct
Front of range/cooktop
6" aluminum duct
Front of range/cooktop
(e)
6" aluminum duct
Range Hood
Visit us @ www.ardaappliances. com
(d)
(c)