Arda HM-20100630 Guide D'utilisation page 7

3. iSLAND MOUNTED HOODS
Installation Instructions
Grounded outlet box
Before You Start...
Grounding Plug
1. Read this manual carefully and completely.
2. aRDa range hoods conform to ETL/CSa
standards. Please check your local building
codes for any additional requirements.
3. The appliance has been manufactured
as class I, therefore ground connection is
necessary. a 110/120 V plug is provided. The
Grounded Grounding Pin
Outlet
range hood must be installed so that that the
plug is easily accessible.
4. This appliance has been designed for use in both ducted and recirculating modes.
Follow the appropriate installation method.
Planning your installation
1. Measure the floor to ceiling height. This hood can be installed on walls between 8"
and 9" tall.
2. Find the centre point of your range/cooktop. Drop a plumb line from your ceiling to
this point on your cooking surface. Mark the ceiling where the plumb line starts.
3. around this point, install cross bracing between the ceiling joists for the island hood
to mount to.
4. Check your range/cook-top User Manual for the specified minimun and maximum
distance above your cooking suface.
5. Decide where the ductwork will run between the hood and the outside. Short straight
duct runs will provide the most air flow.
6. Install 110/120 V electric plug within the dimensions of the decorative chimney (a).
note: all electrical wiring must be done by a qualified person and in accordance with all applicable
codes and standards. This range hood must be properly grounded.
Ceiling joints &
Ceiling duct opening
cross-bracings
Center of
cooking
Floor to
surface to
Ceiling
ceiling
Visit us @ www.ardaappliances. com
- 03 -
- 6 -