Arda HM-20100630 Guide D'utilisation page 8

Island Mounted Hoods
Installing the Duct Work
1. The mark on the ceiling made in the previous
step will be where your 6" ducting will run through
the ceiling. around this point install cross bracing
between the ceiling joists to support the weight of
the hood.
2. Decide where the ductwork will run between the
hood and the outside. Short straight duct runs will
provide the most air flow.
3. arda Island Hoods exhaust vertically up through
the ceiling to the roof. They can be exhausted
sideways above the ceiling to an eave cap.
4. Install a roof or eave cap. Connect a 6" round
metal duct to the cap and work backwards toward
the hood. Ensure connections are completely sealed
with duct tape.
5. Exhaust air must not be discharged into a flue
which is used for the exhaust fumes from other
appliances.
Fixing to the Ceiling
1. Remove the hood from the packaging. Plug unit in
and test all functions before installation.
2. Separate the inner and outer parts of the
telescopic cage.
3. note the side of the cage that has the arrow on it.
When installed, this is the side of the hood that will
have the controls.
4. Centre the upper cage on the ceiling around the
exhaust duct opening. Ensure that (a) the markings
coincide with the cross-bracings between the ceiling
joints and (b) the cage is square with the cooking
surface below.
5. Mark the upper screw holes on the ceiling.
6. Partially screw three of the four screws into the
ceiling at these markings. Insert the upper cage,
rotating to fit (a).
7. Screw in the fourth screw. Tighten the other
three. The cage should now be firmly attached to the
ceiling.
8. Insert the lower cage over the upper cage. adjust
the height to the necessary distance using screws (B)
supplied.
- 7 -
To cave cap
Decorative
Chimney
Duct
Ceiling duct opening
Cross bracings
Front of range/cooktop
Front of range/cooktop
(B)
Lower Cage
6" aluminum duct
To roof cap
Hood
(A)