Arda HM-20100630 Guide D'utilisation page 5

Wall Mounted Hoods
Installing the Ductwork
To Roof Cap
1. Plan where the ductwork will run between
the hood and the outside. arda hoods exhaust
vertically up through the ceiling to the roof.
They can be ducted to the rear behind the
chimney duct through an outside wall. a
short straight duct run will produce the most
Decorative
To Wall cap
Chimney
air flow. Length and elbows will reduce the
Duct
efficiency of the blower.
2. Install a roof or wall cap. Connect a 6"
round metal duct to the cap and work
Hood
backwards toward the hood. Ensure
connections are completely sealed with
duct tape.
3. Exhaust air mUsT NOT be discharged
into a flue which is used for the exhaust
fumes from other appliances.
d
Fixing to the Wall
1. Before mounting the hood, plug in and
test all functions for proper operation.
2. Remove the filters from the bottom of
the hood to prevent damage during the
installation.
3. With assistance, hold the hood
temporarily in position ensuring the
bottom is above the minimun clearance
c
10"
for the cooking surface. Mark on the
wall, the holes for the two mounting
screws.
4. Drill the holes (C) at the distances
indicated. Use the appropriate screws
and screw anchors for your wall type
(e.g. reinforced concrete, drywall, etc.).
If necessary, prepare back wall with cross framing for secure installation.
5. Mount the hood on the wall screws. align it in a horizontal position relative to your
cabinets. When the hood has been adjusted, secure unit by tightening screws (a).
6. Connect a 6" aluminum duct tube (not included) to the exhaust piece using duct tape
on all seals (E).
Visit us @ www.ardaappliances. com
- 03 -
- 4 -