Adhesives - Elcometer 510 S Guide D'utilisation

15 SPARES AND ACCESSORIES (continued)
15.4 MAGNETIC ANCHOR CLAMP
Ideal when testing at height or on vertical
surfaces to prevent damage to the surrounding
coating or harm to the user, the magnetic anchor
clamp connects to the lanyard ring on the top of
the actuator to prevent the actuator from falling
when the dolly is pulled from the substrate.
Description
Magnetic Anchor Clamp Accessory

16 ADHESIVES

The adhesive supplied with the Elcometer 510 is Araldite Standard, a
two-pack epoxy paste which is mixed from approximately equal
volumes of the two components. Measurement by eye is sufficient.
When mixed it should be used within one hour. Curing Times:
24 hours at 25°C (77°F); 3 hours at 60°C (140°F)
®
Araldite is suitable for warm and hot environments. Lower
temperatures can require extended curing times of up to 3 days or
more. The expiry date of the adhesive should be checked before use.
Adhesive which has expired should not be used.
Unused adhesive must be disposed of as special waste unless it has
been fully cured. To dispose of excess adhesive at the end of its shelf life
simply mix the remaining material and allow it to cure before disposal.
Description
®
Araldite Standard Two Part
Epoxy Adhesive; 2x15ml Tubes
A Material Safety Data Sheet for adhesive supplied by Elcometer can be downloaded
via our website:
®
Araldite Standard Two Part Epoxy Adhesive:
https://downloads.elcometer.com/MSDS/araldite_epoxy_adhesive.pdf
Note: Other suitable adhesives include Loctite Hysol 907 and 3M™ Scotch-Weld™
Epoxy Adhesive.
The suitability of any adhesive should be determined by the user. Some coatings
can be adversely affected by adhesives. Some adhesives can be contaminated
by coating environments, solvents etc.
www.elcometer.com
Part Number
T99923797
Part Number
T99912906
® ®
R
®
en-20