Batching - Elcometer 510 S Guide D'utilisation

9 BATCHING

9.1 BATCH FUNCTIONS
The Elcometer 510 Model S gauge can store up to 60 readings in one
batch and has the following batching functions:
Batch/New Batch; Create a new batch - see Section 9.2 for
Ÿ
further information.
Batch/Open Existing Batch; Open an existing batch.
Ÿ
Batch/Edit Batch/Clear Batch; Clear all readings within the
Ÿ
batch - but leaving all batch header information.
Batch/Review Batch; Review the readings, statistics and batch
Ÿ
information - see Section 10 for further information.
Batch/Edit Batch/Delete Batch; Delete the batch entirely from
Ÿ
the gauge.
Batch/Deleted Reading/Delete without Tag; Delete the last
Ÿ
reading entirely.
Batch/Deleted Reading/Delete with Tag; Delete the last reading
Ÿ
but mark it as deleted in the batch memory.
9.2 CREATING A NEW BATCH
Many Standards require the user to record not only the pull-off force
and the nature of the fracture but also details of the test equipment
used; if a support ring was used and its dimensions, if, and by what
means, the coating was cut around the dolly.
This additional information is recorded within the batch header and
transferred to PC to be included on any report within ElcoMaster . For
further information on ElcoMaster visit www.elcometer.com.
To create a new batch select Batch/New Batch and add the following
criteria as required:
Dolly Size & Pull Rate;
Ÿ
(Batch/New Batch/Dolly Size & Pull Rate)
Cutting Device; the type of cutting
Ÿ
device used, if any, to score the
coating around the dolly;
(Batch/New Batch/Cutting Device)
en-13
R
®
Created
Date Last Verified
Time Last Verified
Pull Rate
Dolly Size
Cutting Device
Skirt Type
Back
®
Batch Information
Batch 1
15:31 28/11/2013
25/11/2013
1.00 MPa/s
Dolly Cutter
é
www.elcometer.com
12:49
20 mm
20 STD