Reviewing Batch Data - Elcometer 510 S Guide D'utilisation

9 BATCHING (continued)
The dolly skirt type;
Ÿ
- Select '20mm Standard' for Standard Skirt for 10, 14.2 and
20mm dollies;
- Select '50mm Standard' for Standard Skirt for 50mm dollies;
- Select '14.2mm Thin Substrate' for Thin Substrate Skirt for
14.2mm dollies;
- Select '20mm Thin Substrate' for Thin Substrate Skirt for
20mm dollies
Note: A new batch can not be created if a batch already exists. The existing batch
must be deleted first.
Note: The Elcometer 510 dolly skirt has an integrated support ring, therefore
identifying the dolly skirt used records the use of a support / bearing ring as
required by some standards, together with the support ring dimensions - see
Section 15.3 'Dolly Skirts' on page en-19 for dimensions.
These details can be added and amended until the first reading has
been stored in the batch after which no changes can be made.
This information is saved in the batch header and can be viewed at
any time via Batch/Review Batch/Batch Information.

10 REVIEWING BATCH DATA

10.1 BATCH STATISTICS (Batch/Review Batch/Statistics)
Displays statistical information for the batch including:
Number of readings in the batch (n)
Ÿ
Average reading for the batch (
Ÿ
Lowest reading in the batch (Lo)
Ÿ
Highest reading in the batch (Hi)
Ÿ
Range ( ); the difference between
Ÿ
the highest and lowest reading
in the batch
Standard Deviation (σ)
Ÿ
Coefficient of Variation (cv%)
Ÿ
www.elcometer.com
(Batch/New Batch/Skirt Type)
)
X
Statistics
Batch 1
6
4.01
5.99
32.9
Back
R
7.592
10.00
2.498
Zoom+
en-14