Securing The Dolly - Elcometer 510 S Guide D'utilisation

4 GETTING STARTED (continued)
Dolly Size
1.00, 2.00, 3.00,
10mm
4.00, 5.00
0.40, 0.70, 1.40,
14.2mm
2.00, 2.50
0.20, 0.30, 0.70,
20mm
1.00, 1.20
0.04, 0.08, 0.12,
50mm
0.16, 0.20

5 SECURING THE DOLLY

5.1 USING 10mm, 14.2mm OR 20mm DOLLIES
1 Prepare the surface of the dolly and the coating where the dolly is
to be applied by roughening with the abrasive pad. Then de-
grease and clean both surfaces using a suitable solvent and
allow to dry.
2 Mix equal quantities of the two part Araldite adhesive and apply
a thin, even layer to the prepared surface of the dolly.
®
Araldite adhesive is supplied by Elcometer however, other adhesives can
4
be used - see Section 16 'Adhesives' on page en-20.
3 Press the dolly firmly onto the prepared test surface and apply
pressure to squeeze out excess adhesive which should then be
wiped clean.
4 Allow the adhesive to cure - see Section 16 'Adhesives' on page
en-20.
If testing on vertical surfaces, you may wish to tape the dolly in place
4
during cure.
5 If required, score the coating around the dolly using the dolly
cutter provided.
www.elcometer.com
Pre-defined Pull Rates
(Only the pull-rates listed below are available for selection)
MPa/s
125, 200, 400,
600, 725
60, 100, 200,
300, 360
30, 50, 100,
150, 180
5, 8, 16, 24, 30
psi/s
80, 160, 235,
315, 395
65, 110, 220,
315, 395
65, 95, 220,
315, 380
80, 160, 235,
315, 400
N/s Nmm /s
1.00, 2.00, 3.00,
4.00, 5.00
0.40, 0.70, 1.40,
2.00, 2.50
0.20, 0.30, 0.70,
1.00, 1.20
0.04, 0.08, 0.12,
0.16, 0.20
®
R
-2
en-8