Feed Slot" Operator Unit; Turning The Machine On; Initialization Process; Starting The Shredding Process - Intimus FlashEx Instructions D'opération

GB
= "Lubricate cutting mechanism" pilot lamp
7
(Fig . 1/7)
Lights up if the machine needs to be lubricated.
NOTE!
If the safety glass for the oiling process is open,
the lamp starts flashing.
= "Material jam" pilot lamp (Fig . 1/8)
8
Lights up if the cutting mechanism is jammed.
= "Cutting mechanism ready" / "Cutting mecha-
9
nism not ready" curved pilot lamps (Fig . 1/9)
Lights up green if the cutting mechanism can be
fed. Lights up red if the cutting mechanism cannot
be fed.

3 .2 "Feed slot" operator unit

1
1
Safety glass
2
Feed flap
Fig. 2 intimus FlashEx feed slot
= Safety glass (Fig . 2/1)
1
The machine only runs if the safety glass is closed.
= Feed flap (Fig . 2/2)
2
Feed the material through the device's feed flap.
This starts the cutting mechanism.

3 .3 Turning the machine on

Briefly press the function button (Fig. 1/1).
¾ The LED display on the function button lights
up to indicate "ready for operation."
¾ You can now feed the machine.

3 .4 Initialization process

NOTE!
During the initialization process, please do not
feed any material into the shredder!
Start the initialization process (when the machine
is off):
1 . Briefly press the function button Fig. 1/1.
¾ The machine turns on.
2 . Briefly press the forward button Fig. 1/2.
93902 1 02/16
¾ The initialization process starts. The cutting me-
chanism switches five times between forward
and backward operation.
¾ The cutting mechanism stands still. You can now
feed the machine.

3 .5 Starting the shredding process

DANGER!
Risk of injury! Damage to the machine!
☞ Remove batteries from the device befo-
CAUTION!
Material jam! Damage to the machine!
Ì Feed the data carriers into the machine
Ì If too much material has reached the
2
Feeding through the feed flap (Fig . 3/2)
Slip small data carriers, like USB sticks, mobile phones
000087
or SSD disks, through the feed flap into the cutting me-
chanism.
¾ The shredding process starts automatically.
¾ After destroying the data carrier, the machine
shuts off automatically.
1
Safety glass
2 Feed flap
Fig. 3 Feeding through the feed flap
Feeding through the safety glass (Fig . 3/1)
1 . For larger data carriers, e.g. mini tablets, push the
safety glass back and feed the data carrier into the
cutting mechanism.
2 . Close the safety glass again.
3 . Briefly press the forward button Fig. 1/2.
¾ The shredding process starts.
¾ After destroying the data carrier, the machine
shuts off automatically.
re shredding it!
individually, one after another! This lets
the intimus FlashEx reach its best per-
formance.
cutting mechanism, see „Material jam",
p. 13.
1
FlashEx
2
000084
11