Technical Data - Aventics NL1 Serie Mode D'emploi

AVENTICS | NL1 / NL2 / NL4 / NL6 | R412015554–BAL–001–AD | English
8
Conversion of 3/2-way valves
A change in the flow direction occurs for all components
by rotating them 180° about the vertical axis. The
pressure gauge must therefore be exchanged.
8
Conversion of filling valve with continuous
pressure supply
O To change the flow direction, install the component
after rotating it 180° about the transverse axis.
10 Troubleshooting
Malfunction Possible cause
Pressure/ Working
flow level is pressure too low
not reached
or slowly
decreases.
Leakage in the
tubing

11 Technical data

General data
Mounting orientation
Further technical data can be found in the online
catalog at www.aventics.com/pneumatics-catalog.
Remedy
W
Set a higher
working pressure
W
Check tubing
diameter
Check tubing and its
fittings
Any
8