Troubleshooting - TechniSat TECHNIPOLAR 1 Mode D'emploi

End of the season:
If the air conditioner is not going to be used for an extended period:
> Empty the condensation water container completely and leave the lower
drain cap open until the residual water has drained away. As soon as the
tank is completely empty and no more water drains out, replace the rubber
stopper.
> Remove and clean the filter, let it dry completely, and then reinsert it.
> Remove the batteries from the remote control.
> Store the air conditioner in a cool, dry place, away from direct sunlight,
extreme temperatures and excessive dust.

10 Troubleshooting

Problem
The air conditioner does
not start / does not
switch on.
The air conditioner only
runs for a short time.
The air conditioner works
but does not cool.
Cause
No power.
Power cord not plugged
in.
Protection circuit
activated.
The exhaust hose is
kinked or incorrectly
connected.
The air outlet / exhaust
hose is blocked.
Windows / curtains /
drapes are open.
Other devices in the room
are causing heat (e.g.
television, stoves, hair
dryer).
The exhaust hose was
not installed or was not
directed outside.
The cooling capacity
is not suitable for the
room in which the air
conditioner is being
operated.
Solution
Check the electrical
supply.
Plug the power cord into
a wall outlet.
Wait 30 minutes and
then try again. If the
error persists, contact our
service department.
Follow the steps in the
operating instructions for
connecting the exhaust
hose
Check the air outlet /
exhaust hose for possible
dirt contamination.
Protect the room from
sunlight and close all
windows.
Switch off all additional
devices in the room.
Install the exhaust hose
correctly.
Pay attention to the
technical data of the air
conditioner.
DE
EN
FR
IT
NL
PL
49