Fan Mode; Automatic Mode; Timer Mode; Programming The Timer - TechniSat TECHNIPOLAR 1 Mode D'emploi

6.6 Fan mode

If you use the unit in this mode, the exhaust hose does not need to be connected.
> Press the MODE button (1) several times until Fan (10) lights up. Press the
FAN button (5) several times to select the desired fan speed, where High,
Medium, or Low can be selected.
Automatic control is not available in this mode.

6.7 Automatic mode

In automatic mode, the unit independently decides which mode to use based on
the current room temperature:
- Up to 20°C room temperature
- Between 20°C and 23°C
- Above 23°C room temperature
> Press the MODE button (1) several times until all mode LEDs are switched off
and a rotating bar appears on the display.
> Press the FAN button (5) several times to select the desired fan speed, where
High, Medium, or Low can be selected.

7 Timer mode

The timer can be used to automate switching the unit on or off.
Efficient use of the timer mode saves electricity, since the unit is only in operation at
the set times.

7.1 Programming the timer

Delayed switching on
> First select the mode and the desired settings (fan speed, temperature) while
the unit is in operation. Then switch off the unit.
> When the unit is switched off, press the TIMER button (2). The timer LED (11)
and the number of hours flash on the display.
> Press the TIMER button again several times within 5 seconds to set the hours
by which the unit should be switched on after a delay.
The timer can be set in 1 hour intervals from 1 hour to 24 hours.
= heat mode
= fan mode
= cool mode
DE
EN
FR
IT
NL
PL
43