Cleaning; Cleaning The Unit; Activities At The Start / End Of The Season - TechniSat TECHNIPOLAR 1 Mode D'emploi

9.2 Cleaning

Switch off the unit before cleaning or performing maintenance by pressing
the POWER button on the control panel or remote control. Wait a few
minutes and then pull the plug out of the wall outlet.

CLEANING THE UNIT

> Clean the unit with a slightly damp cloth and then dry it completely with a
dry cloth.
Never clean the air conditioner with water. Never use petrol, alcohol or
solvents to clean the unit. Never spray insecticides or the like onto the unit.
CLEANING THE FILTER
To ensure that your air conditioning system
works efficiently, you should clean the filter
every week of operation.
> The filter can be removed as shown in the
figure on the right.
> Remove dust accumulation on the filter
with a vacuum cleaner.
> If the filter is very dirty, immerse it in warm
water and rinse several times. The water
should be lukewarm.
> After washing, let the filter dry completely
and then put it back in place.
Never use a filter that is still wet. Doing so
can damage the unit.
WARNING!
When the filter housing is open, do not
touch the cooling fins inside the unit. These
are sharp and can cause cuts.

9.3 ACTIVITIES AT THE START / END OF THE SEASON

Start of the season:
> Check the power cord and plug for damage. Check the basic installation of
the unit and the location according to these instructions.
48