Bosch CTL636E.1 Mode D'emploi page 54

Machine à expresso entièrement automatique
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

en
Simple troubleshooting
Problem
The coffee grounds are
not compact and are too
wet.
Grinding level adjustment
is stiff.
Brewing unit cannot be
inserted.
Protective cover of the
brewing unit cannot be
properly attached.
There is water under the
drip tray.
Display shows "12:00"
Display shows
"Milk container
connected?"
despite connected milk
container.
Display shows
"Overvoltage or
undervoltage"
Display shows
"Leave device to cool"
Display shows,
for example:
"Fault: E0510"
Display shows
"Fill bean container"
although the container is
already full, or the grinder
is not grinding any beans.
50
Cause
The grinding setting is too fine
or too coarse, or not enough
ground coffee has been used.
Too many beans in the
grinding unit.
Brewing unit is in the wrong
position.
Brewing unit is locked.
Brewing unit is not locked.
This water is condensed.
Power failure or appliance
switched off at mains.
Container is outside the range
of the sensor.
Material e.g. milk carton is not
recognised.
Voltage too high or too low.
Appliance is too hot.
The appliance has a fault.
Beans are not falling into the
grinding unit (beans too oily).
Solution
Adjust the grinding unit to a
coarser or finer setting, or use
2 level measuring spoons of
ground coffee.
Dispensing a drink from
coffee beans. Only make any
sub sequent changes to the
grinding level in small steps.
Insert the brewing unit
according to the instructions,
see the section "Cleaning the
brewing unit".
Unlock the brewing unit, see
the section "Cleaning the
brewing unit".
Lock the brewing unit, see the
section "Cleaning the brewing
unit".
Do not insert drip tray without
cover.
Re­enter values; do not switch
the appliance off at the mains
or select the "off" option in the
Clock displ. menu.
Position the container at the
right edge.
Confirm the display request
with "Yes" or use the enclosed
milk container.
Contact electricity or grid pro­
vider. Have the power supply
checked by an expert.
Switch off appliance for
30 minutes.
Proceed according to the
display screen.
Gently tap the bean container.
Possibly change the type of
coffee. When the bean con­
tainer is empty, wipe it with a
dry cloth.

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Ctl636e 1 série

Table des Matières