Panasonic WV-Q116 Instructions page 4

WV-Q116E_E.qxd 05.2.2
9. Remove the plate from the camera
mounting base (combination camera
accessory).
10. Attach the camera mounting base to
the bracket. Adjust the lock plate so it is
in the orientation show in the following
illustration, and then tighten the four
M4-L 8 Screws (provided).
Cables
M4-L8
11:05 Page 4
Plate
Bracket
Orientation
of installation
Lock plate
- 4 -
11. Connect the fall prevention wire to the
camera mounting base.
Note: Tug on the Fall Prevention Wire to
make sure it is secure.
12. Install the camera to the camera mount-
ing base.
*The top case is not shown in the fol-
lowing illustration.
Rotate
Camera
Base
unit