Assembling The Product - Duux Edge Manuel Utilisateur

5.2.2. Assembling the product

1. Carefully place the product on a soft, stable
and flat surface.
2. Remove the rubber protection plugs
the floor stand mounting holes
3. Place the first floor stand
and align the holes on the floor stand with
the mounting holes
6
4. Attach the first floor stand
with the bolts using a screwdriver.
r
5. Perform step 3. and 4. for the second floor
stand.
6. Put the product in an upright position on the
floor.
- The product is now ready to use.
from
5
.
6
on the product
q
.
to the product
q
5.2.3. Mounting the mounting bracket
NOTICE
• Never mount the product on the wall with the
floor stands placed on the product.
• Take a minimal spacing into account when
mounting the mounting bracket. See the next
image.
820
20
435
350
465
1. Determine the desired position of the
mounting bracket
e
of the mounting bracket accordingly.
2. Drill a hole with a diameter of 6 mm at each
of the 4 marks.
3. Place a plug
into each of the drilled holes
u
and use a hammer to fix the plug.
435
mm
and mark the 4 holes
15