asalvo L-FIX Manuel D'instructions page 31

EN
INSTRUCTIONS
4
INSTALLED WITH ISOFIX, TOP
TETHER AND BELT
Step1: PUll out the top tether, and
press the release button, pull the top
tether long enough to hang the latch
on the back of the car seat.
Fixed the latch on the fixed point,and
the position of the fixed point are
shown in the picture(one of the three
positions).Make sure the hook is
tightened up.
Step2. First pull out the belt from
the belt ALR. Diagonal belt through
Guidance 1 and lap belt through the
belt slot, then put them together
through Guidance 3 slot.
NOTE: Make sure that the diagonal
seatbelt section runs over your
child's shoulder bone, and not in
front of his or her neck.
Step3: Lock the tip of the buckle into
the vehicle seat buckle with a CLICK
noise. Follow the direction of arrow
to tighten belt, and put redundant
belt into cloth cover.Shake the child
safety car seat to make sure it is
securely attached.
CAUTION! The diagonal seat
belt section must run diagonally
backward. You can adjust the
course of the belt with your vehicle's
adjustable belt deflector on both
sides.