Klein Tools True RMS CL600 Manuel D'instructions page 4

ENGLISH
To ensure safe operation and service of the meter, follow these
instructions. Failure to observe these warnings can result in
severe injury or death.
• Before each use verify meter operation by measuring a known
voltage or current.
• Never use the meter on a circuit with voltages that exceed the
category based rating of this meter.
• Do not use the meter during electrical storms or in wet weather.
• Do not use the meter or test leads if they appear to be damaged.
• Use only with CAT IV rated test leads.
• Ensure meter leads are fully seated, and keep fingers away from
the metal probe contacts when making measurements.
• Do not open the meter to replace batteries while the probes are
connected.
• Use caution when working with voltages above 25V AC RMS or
60V DC. Such voltages pose a shock hazard.
• To avoid false readings that can lead to electrical shock, replace
batteries when a low battery indicator appears.
• Do not attempt to measure resistance or continuity on a live circuit.
• Always adhere to local and national safety codes. Use personal
protective equipment to prevent shock and arc blast injury
where hazardous live conductors are exposed.
AC
Resistance (in Ohms)
Double Insulated Class II
Diode
V Voltage (Volts)
Warning or Caution
To ensure safe operation and service of this meter, follow all
warnings and instructions detailed in this manual.
Risk of Electrical Shock
Improper use of this meter can lead to risk of electrical shock. Follow
all warnings and instructions detailed in this manual.
Risk of Electrical Shock
Application around and removal from UNINSULATED HAZARDOUS
LIVE conductors is permitted.
AC Measurement
Negative Reading
Auto Ranging
MIN Minimum Value Hold
Auto Power Off
k kilo (value x 10
m mili (value x 10
V Volts
4
WARNINGS
SYMBOLS ON METER
SYMBOLS ON LCD
)
3
)
-3
DC
Audible Continuity
Ground
A Amperage (Amps)
DC Measurement
Data Hold
MAX Maximum Value Hold
Low Battery
Audible Continuity
M Mega (value x 10
Ohms
A Amps
)
6