Putting Into Operation; Ordering Replacement Parts; Disposal And Recycling; Care And Maintenance - EINHELL BT-HS 12 Mode D'emploi D'origine

Anleitung_BT_HS_12_SPK1:_
GB

6. Putting into operation

Join the 12 V connector (Fig. 1 Item 5) to the
vehicle's cigarette lighter socket. If there is no
cigarette lighter socket, insert the 12 V connector
(Fig.1 Item 5) in the 12 V socket of the adapter cable
(Fig.1 Item 6). Then connect the pole clamps (+/-) to
the corresponding poles of the vehicle's battery.
Fit the required drive bit onto the square drive mount.
Set the hammer-action screwdriver to the correct
direction of rotation.
Apply the drive bit to the screw head and press the
ON/OFF switch.
Carefully insert the bolt or nut in the thread before
you actuate the electric screwdriver. A torque of
approximately 40-50 Nm per pulse is generated on
standard bolts of size M12/M14. On motor cars, each
bolt should be tightened with two pulses. Each bolt
should then be checked with one additional pulse. A
total torque of between 120 and approximately 150
Nm is thus achieved.
Three pulses are recommended on heavy vehicles
(e.g. luxury cars, off-road vehicles, etc.). Each bolt
should then be tightened in diametrically opposed
order with one additional pulse. A total torque of
approximately 170 - 230 Nm is thus achieved.
Check the threaded connections for signs of damage
after tightening.
Important!
Always tighten and check wheel nuts with a torque
wrench set to the torque specified by the
manufacturer of the vehicle in question.

7. Care and maintenance

Wherever possible, clean the surface with only a soft
dry cloth - do not use aggressive solvents. If abso-
lutely necessary, use a slightly damp rag to remove
dirt.
The following are excluded from the warranty:
Wearing parts
Damage resulting from improper use or
tampering by third partiesrequire additional
maintenance.
10
11.08.2010 14:09 Uhr Seite 10

8. Ordering replacement parts

Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info

9. Disposal and recycling

The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.
10. Storage
Store the equipment and accessories out of children's
reach in a dark and dry place at above freezing
temperature. The ideal storage temperature is
between 5 and 30 °C. Store the electric tool in its
original packaging.