Safety Regulations; Putting Into Operation; Accessories; Maintenance And Cleaning - EINHELL DSS 260/1 Instructions D'utilisation Et D'entretien

Anleitung DSS 260/1 09.03.2004
GB
Please note!
The power of the tool will be reduced if you use a
hose that has too small an inner diameter or
which is too long.

5. Safety regulations

Take suitable precautions to protect yourself and
your environment from potential hazards.
Never put the impact screwdriver to any use other
than that intended.
Keep pneumatic tools safe from children.
Always concentrate while you work. Do not work if
you are tired.
Use only a quick-release coupling to connect up
the air supply.
It is imperative to use a pressure reducer to set
the working pressure.
Never use oxygen or combustible gases as an
energy source.
Always disconnect the tool from the air supply
before carrying out any repairs or maintenance
work.
Use only original replacement parts.
Never allow the tool to run unloaded at full idle
speed for any length of time.
Wear the necessary protective clothing when
working with the impact screwdriver.
Wear ear-muffs and safety gloves!

6. Putting into operation

Screw the plug-in nipple included in delivery into the
air connection, having first wrapped 2 - 3 layers of
sealing tape around the thread. Attach the required
drive socket/bit to the square drive mount. Adjust the
direction of rotation on the guide lever.
R = Reverse / loosen the screw, F = Forward /
tighten the screw. In addition, the reversing lever
also features a regulator for setting the air pressure /
torque for both reverse and forward. Grid position 1 =
minimum speed, grid position 3 = maximum torque.
Place the drive socket/bit on the head of the screw.
Actuate the extractor. The device is connected to the
source of compressed air by means of a flexible
compressed air hose with a quick-action coupling.
For optimum performance from your screwdriver, use
a compressed air hose with a clear opening of 9 mm.

7. Maintenance and cleaning

Observance of the following maintenance
instructions will ensure that this quality tool gives you
years of troublefree service. Regular lubrication is
6
9:18 Uhr Seite 6
vital for the long-term, reliable operation of your
impact screwdriver. Use only special tool oil for this
purpose. You can choose from the following options
for lubricating the tool:
7.1 By mist oiler
A complete conditioning unit includes a mist oiler and
is fitted to the compressor.
7.2 By hand
Each time before you use your impactscrewdriver,
feed 3-5 drops of special tool oil into the air
connection. If the pneumatic tool has not been used
for several days, you must feed 5-10 drops of oil into
the air connection before you switch on. Keep your
pneumatic tool in dry rooms only.

Accessories

Special oil for pneumatic
tools 500 ml Art. No. 41.383.10
The warranty does not cover:
Wearing parts
Damage caused by an unacceptable level of
working pressure.
Damage caused by unconditioned compressed
air.
Damage caused by improper use or unauthorized
tampering.