Maytag YMEDE250XL0 Mode D'emploi page 22

FOR SERVICE TECHNICIAN ONLY - DO NOT REMOVE OR DESTROY
Machine Control
Electronics
Assembly
FRONT
Figure 13b. Locate the electronic assemblies
(on some models).
Accessing the
Machine Control Electronics
1. After locating the machine control electronics,
remove the screws that hold the machine control
electronics bracket in place.
2. Slide the bracket over the top of the drum
to access the machine control electronics
connectors and mounting screw. See figure 14a
or 14b (depending on model).
Machine Control
Electronics Assembly
Mounting
Screw
Figure 14a. Remove machine control
electronics from mounting bracket
(on some models)
User Interface and
Housing Assembly
(inside)
FRONT
Machine Control
Electronics
Bracket
Machine Control
Electronics Assembly
Mounting
Screw
Figure 14b. Remove machine control
electronics from mounting bracket
(on some models)
Removing the
Machine Control Electronics
1. Remove all the wire connections to the machine
control electronics. See figure 15, page 23.
2. Remove the screw holding the machine
control electronics assembly to the mounting
bracket. See figure 14a or 14b (depending
on model).
3. There are two plastic legs on the front of the
machine control electronics that slide under the
mounting bracket.
 There is one plastic leg on the rear of the
machine control electronics that slides under
the mounting bracket.
 There is a locking tab on the bottom of the
machine control electronics that snaps into the
mounting bracket.
Press the locking tab on the bottom of the
machine control electronics and slide the
assembly to the front, then lift.
PAGE 22
FRONT
Machine Control
Electronics
Bracket