GE Monogram ZET1R Manuel Du Propriétaire page 44

Lift-off
oven
door—
removal
Probe
44
The door is very heavy. Be careful when removing
and lifting the door.
Do not lift the door by the handle.
To remove the door:
1 Fully open the door.
2 Pull the hinge locks down toward the door
frame, to the unlocked position. A tool, such
as a small flat-blade screwdriver, may be
required.
3 Firmly grasp both sides of the door at the top.
4 Close door to the door removal position,
which is most of the way and lift it up and out
until the hinge arm is clear of the slot.
To replace the door:
1 Firmly grasp both sides of the door at the top.
2 With the door at the same angle as the
removal position, seat the indentation of the
hinge arm into the bottom edge of the hinge
slot. The notch in the hinge arm must be
fully seated into the bottom of the slot.
3 Fully open the door. If the door will not fully
open, the indentation is not seated correctly in
the bottom edge of the slot.
4 Push the hinge locks up against the front
frame of the oven cavity, to the locked
position.
5 Close the oven door.
The temperature probe may be cleaned with
soap and water or a soap-filled scouring pad.
Cool the temperature probe before cleaning.
Scour stubborn spots with a soap-filled scouring
pad, rinse and dry.
Do not immerse the temperature probe in water.
Do not store the temperature probe in the oven.
Care and Cleaning
Wall Oven
Slot
Hinge lock
Pull hinge locks down to unlock
Removal position
Bottom
edge of
slot
Hinge
arm
Hinge
lock
Push hinge locks up to lock
Hinge arm
Indentation