GE ZET2 Instructions D’installation

installation
instructions
30" (76.2 cm) Built-in
Wall Oven
ZET1, ZET2
if you have questions, call 1.800.GE.CARES or visit our website at:
ge.com
Before You Begin
Read these instructions carefully and completely.
. IMPORTANT=save these
instructions for local inspector's use.
. IMPORTANT-observe a,
governing codes and ordinances.
, Note to lnstallermBe sure to leave these
instructions with the consumer.
, Note to ConsumermKeep these
instructions for future reference.
, Proper installation is the responsibility
of the installer and product failure due
to improper installation is NOT covered
under warranty.
= NOTE=This appliance must be properly
grounded.
. ATTENTION INSTALLER
All electric wall ovens must be hard wired
(direct wired) into an approved junction
box. A plug and receptacle is NOT permitted
on these products.
Parts Include
(Appearance may vary.)
3/4" Wood
Screws
(8-18 x .750 flat-head
5/8" Wood
Screws
(8A8 x .625 truss-head
Phillips wood screws)
Phillips w_
I% ___ Metal Botto .m.
Trim Assembly
31-10649-3 11-07 JR
rials Needed
Strain Relief Clamp Junction
for 1/2" conduit Box
Wire Nuts
36" (91 cm)
of String
Tools ceded
1/8" Drill Bit and
Electric or Hand Drill
Phillips
Screwdriver
Adjustable Wrench