Installation/Connection; Basic Procedure - JVC KD-X241 Manuel D'instructions

TROUBLESHOOTING
Symptom Remedy
• Sound cannot be heard • Reconnect the Android device.
during playback. • If in [AUDIO MODE], launch any media player
• Sound output only from application on the Android device and start playback.
the Android device. • If in [AUDIO MODE], relaunch the current media player
application or use another media player application.
• Restart the Android device.
• If this does not solve the problem, the connected Android
device is unable to route the audio signal to unit. ( 12)
Cannot playback at • Make sure JVC MUSIC PLAY APP is installed on the
[AUTO MODE]. Android device. ( 5)
• Reconnect the Android device and select the appropriate
control mode. ( 6)
• If this does not solve the problem, the connected Android
device does not support [AUTO MODE]. ( 12)
"NO DEVICE" or "READING" • Switch off the developer options on the Android device.
keeps flashing. • Reconnect the Android device.
• If this does not solve the problem, the connected Android
device does not support [AUTO MODE]. ( 12)
Playback is intermittent or Turn off the power saving mode on the Android device.
sound skips.
"CANNOT PLAY" • Make sure Android device contains playable audio files.
• Reconnect the Android device.
• Restart the Android device.
If you still have troubles, reset the unit. ( 3)
14
ENGLISH

INSTALLATION/CONNECTION

Warning
• The unit can only be used with a 12 V DC power supply, negative ground.
• Disconnect the battery's negative terminal before wiring and mounting.
• Do not connect Battery wire (yellow) and Ignition wire (red) to the car chassis or Ground wire
(black) to prevent a short circuit.
• Insulate unconnected wires with vinyl tape to prevent a short circuit.
• Be sure to ground this unit to the car's chassis again after installation.
Caution
• For safety's sake, leave wiring and mounting to professionals. Consult the car audio dealer.
• Install this unit in the console of your vehicle. Do not touch the metal parts of this unit during
and shortly after use of the unit. Metal parts such as the heat sink and enclosure become hot.
• Do not connect the wires of speakers to the car chassis or Ground wire (black), or connect
them in parallel.
• Connect speakers with a maximum power of more than 50 W. If the maximum power of
the speakers is lower than 50 W, change the [AMP GAIN] setting to avoid damaging the
speakers. ( 10)
• Mount the unit at an angle of less than 30º.
• If your vehicle wiring harness does not have the ignition terminal, connect Ignition wire (red)
to the terminal on the vehicle's fuse box which provides 12 V DC power supply and is turned
on and off by the ignition key.
• Keep all cables away from heat dissipate metal parts.
• After the unit is installed, check whether the brake lamps, blinkers, wipers, etc. on the car are
working properly.
• If the fuse blows, first make sure the wires are not touching car's chassis, then replace the old
fuse with one that has the same rating.

Basic procedure

1 Remove the key from the ignition switch, then disconnect the [ terminal of the car
battery.
2 Connect the wires properly.
See Wiring connection. ( 16)
3 Install the unit to your car.
See Installing the unit (in-dash mounting). ( 15)
4 Connect the terminal of the car battery.
5 Reset the unit. ( 3)