HeatStar HSRP37GL Instructions D'utilisation Et Manuel Du Propriétaire page 8

HEATER MOUNTING INSTRUCTIONS
After selecting the heater installation location and after verifying and
ensuring that all of the above placement requirements are fulfilled,
mount the heater as follows:
1. The wall mounting must be carried out using anchors adapted to
the wall on which the heater will be installed. The use of dowels
with 3/8 "diameter is recommended. The surface on which it is
installed must be solid and suitable to support the weight of the
unit.
2. Position the heater as shown in Figure 8 and Figure 9 and slide
the heater mounting clip over the bracket and install the bolt
through the clip and bracket.
3. Thread the hex nut onto the bolt and tighten securely.
Mounting Arm (From Ceiling)
FIGURE 10
Mounting
MODEL
Angle
HSRP37GL
HSRP37GL
HSRP37MT
Mounting
MODEL
Angle
HSRP37GL
HSRP37GL
HSRP37MT
0
B
A
Bracket
Combination
40� A-1
30� B-3
TABLE 3 Mounting to a Wall (*Achieved by bracket length)
Bracket
Combination
35� B-2
10� B-1
TABLE 4 Mounting to a Ceiling (*Achieved by bracket length)
Outdoor Patio Heater
MOUNTING POSITIONS
• After following the instructions for mounting your Patio Heater in
the Owner's Manual, refer to Figures 10,11, and 12 and Tables 3
and 4 for the specific allowable angles for positioning your heater.
• The Glass Front heaters are certified from the angles of 0-40°and
the Metal Front heaters are certified from 0-30°.
• The angles included in the tables are when mounted
perpendicularly to the wall and ceiling. If mounted to a wall or
ceiling that is already at an angle, contact tech service for other
possible mounting angles.
Mounting Arm (From Sidewall)
B
A
0
FIGURE 12
MINIMUM CLEARANCES TO COMBUSTIBLE SURFACES
TOP SIDES
13" 16"
13" 16"
MINIMUM CLEARANCES TO COMBUSTIBLE SURFACES
TOP SIDES
13" 16"
13" 16"
8
Operating Instructions and Owner's Manual
FIGURE 11
Mount Bracket
BACK*
8"
8"
BACK*
8"
16"
BELOW
48"
48"
BELOW
48"
48"