Connecting The Ductwork; Electrical Connection; Electrical Grounding Instructions; Install Motor - Beko CHP 30100 CF Mode D'emploi

4
4.3.3 Connecting the
ductwork
• Install ductwork, making connections in the
direction of air ow as illustrated.
• Push duct over the exhaust outlet.
• Wrap all duct joints and the ange connections
with duct tape for an airtight seal.
• Make the same connection in the wall or ceiling
vent exit.

4.3.4 Electrical connection

Electrical Shock Hazard
Turn o power circuit at the service
panel before wiring this unit. 120
VAC, 15 or 20 Amp circuit required.

Electrical grounding instructions

This appliance is tted with an electrical junction
box with 3 wires, one of which (green/yellow)
serves to ground the appliance.
14 / 59 EN
To protect you against electric shock, the green
and yellow wire must be connected to the
grounding wire in your home electrical system,
and it must under no circumstances be cut or
removed.
Failure to do so can result in death or electrical
shock.
Remove the knockout and the Junction box cover
and install the conduit connector (cULus listed) in
junction box.

4.3.5 Install Motor

• From the inside of the hood, slip motor into the
attachment slot on the left.
• Rotate motor upwards until it snaps into the
spring clip on the right.
• Secure the motor to the hood with the 2 machi-
ne screws and 2 lock washers.
IMPORTANT: Connector ends
are designed to mate only one way.
Match at and round connectors as
shown.
Range Hood / User Manual