List Of Materials; Parts Supplied; Parts Not Supplied; Tools/Materials Required - Beko CHP 30100 CF Mode D'emploi

3

3.1 List of Materials

3.1.1 Parts supplied

Removing the packaging
Remove carton carefully, Wear
gloves to protect against sharp
edges.
WARNING: Remove the protec-
tive covering the product before
putting into operation.
• Hood canopy.
• Blower.
• Duct transition.
• Lamp already installed.
• Gr ter.
• Hardware bag with:
– Use, care and installation guide
– 2 hollow wall anchors with 2 screws to
secure hood to the wall at the bottom
– 4 Wood screws to secure the wood support
to the wall
– 4 Phillips head screws to secure the transition
to the hood outlet on the top
– 6 Phillips head screws to secure hood to the
cabinet
– 2 Safety screws and 2 lock washers to secure
the blower
– 2 Flat washers for hollow wall anchors
– Torx 20 adapter

3.1.2 Parts not supplied

Tools/Materials required

• Wire nuts
• 10" rounded metal duct length to suit installation
8 / 59 EN
• Measuring tape
• Pliers
• Gloves
• Knife
• Safety glasses
• Electric drill with 5/16" and 3/8" Bits
• Strain relief
• Spirit level
• Duct tape
• Screwdrivers:
– Phillips (Posidrive) # 2
– Torx # 2
• Wire cutter/stripper
• Masking tape
• Hammer
• Saw, jig saw or reciprocating saw
Nr.of Speeds
Controls
Volts
Frequency
Total Power
(motor + lamps)
Plug type
-
tance above
cooktop
Range Hood / User Manual
ducted out only
30" - 500 CFM
36" - 910 CFM
4
2 x 6.5 W LED
120 V
60 Hz
30" - 450 W
36" - 900 W
30" (gas cooktop)