Unpacking The Model Av1-Led; Introduction To The Model Av1-Led; Mounting The Model Av1-Led - Federal Signal AV1-LED Manuel D'installation Et D'entretien

Installation and Maintenance Manual
■

Unpacking the Model AV1-LED

After unpacking the Model AV1-LED, examine it for damage that
may have occurred in transit. If the product has been damaged, do
not attempt to install or operate it. File a claim immediately with the
carrier stating the extent of the damage. Carefully check all envelopes,
shipping labels and tags before removing or destroying them. If any
parts are missing, please call Federal Signal Customer Support at
708-534-4756.

Introduction to the Model AV1-LED

The Model AV1-LED combination audible/visual signal features a
100-percent polycarbonate housing that is rated for Type 3R rain-
tight applications. The Fresnel lens provides superior visibility in all
directions. Available lens colors include amber, blue, clear, green, and
red. Jumper settings enable you to select a fast or slow flash rate and
whether the buzzer and/or LED operate intermittently or continuously.
The AV1-LED design provides three mounting configurations. The
black base will accommodate mounting to a 1/2-inch NPT pipe, a
4-inch octagonal electrical box, or any flat surface. The surface-mount
gasket serves as a template for preparing a flat surface with appropriate
mounting holes.
All Model AV1-LED units feature a unique twist-and-lock lens to enable
tool-free access to the LED light. The integrated buzzer provides 85 dB
output at 10 ft (95 dB at 1 m). Two voltage variations are available:
24 Vdc and 120 Vac. Each Model AV1-LED is factory-assembled with
two color-coded leads for wiring to a junction box. If necessary, installers
can remove the leads and connect the power supply to the Model AV1-
LED directly to the terminal block located in the base of the unit.

Mounting the Model AV1-LED

This section describes how to pipe-mount and surface-mount the light. To
mount the light on a vertical surface, use a separately purchased Model
LWMB2 (wall mounting bracket) or LCMB2 (corner mounting bracket)
mounting kit (Table 1 on page 18). For weatherproof installation, the
light must be mounted vertically with the lens facing upwards.
Model AV1-LED Lights
6