Starting A Wash Cycle - Whirlpool 920 Serie Guide D'utilisation Et D'entretien

STA RT I NG Y O U R D IS HW A S H E R

Starting a wash cycle

1. Load the dishwasher. See the "Loading
Your Dishwasher" section.
2. Spin the spray arms. They should
turn freely.
3. Add detergent. See the "Using the
Dispensers" section.
4. Add rinse agent, if needed.
Stopping the dishwasher
You can stop your dishwasher anytime
during a cycle. All you have to do is:
•
Open the door slightly. Wait for any filling
or spraying action to stop before opening
the door all the way. Close door to
continue cycle.
OR
•
Press Cancel/Drain. Once pressed, a
2-minute drain starts. See the "Setting the
Controls" section.
6
5. Close door firmly until it latches.
6. Run hot water at the sink nearest the
dishwasher until water is hot.
Turn water off.
7. Press a Cycle pad. If desired, press one
or more Option pads. See the
"Setting the Controls" section.
The dishwasher starts filling
once you press a cycle pad
unless you select the delay
wash cycle. You may press Option pads
as the machine is filling.
The pad indicator glows red when a cycle or
an option is selected.