Changing A Cycle Or Option Setting; Adding An Item During A Cycle - Whirlpool 920 Serie Guide D'utilisation Et D'entretien

Changing a cycle or option setting

During the first minute
of a cycle
1. Press new Cycle and/or Option pads.
2. Check the detergent dispensers. They
must be filled properly for the new cycle.
After the first minute
of a cycle
1. Press Cancel/Drain. A 2-minute drain
cycle starts. Wait for drain cycle to finish.
2. Press a new Cycle pad.
3. If desired, press one or more Option
pad(s).
4. Check the detergent dispensers. They
must be filled properly for the new cycle.

Adding an item during a cycle

You can add an item to the dishwasher
anytime before the main wash portion of a
cycle. See the "Setting the Controls" section.
1. Lift up the door latch to stop the cycle.
Wait for spraying action to stop before
opening the door.
2. Open the door and add the item.
3. Close the door, but do not latch it. Wait
30 seconds for the air in the dishwasher
to warm up. Doing so reduces the
amount of moisture in the vent when
restarting a cycle.
4. Close the door firmly until it latches. The
dishwasher resumes the cycle.
SE TTI NG TH E CON T ROL S
CYCLES
RINSE
LOW
POTS
ENERGY
NORMAL
WASH
PANS
CHINA
LATER
OPTIONS
HIGH
-N- TEMP AIR DRY AIR DRY
WASH
15