Meec tools 015275 Mode D'emploi page 37

MAINTENANCE
WARNING!
• Electrical safety. Pull out the plug before
working on the product.
• Risk of personal injury. Make sure that
the product and all connected devices
are pressureless before working on the
product.
CLEANING
• The pump must be flushed with fresh
water if chlorinated water or water
containing sedimented contaminants is
pumped.
• To remove clogging or blockage, remove
the suction tube from the pump inlet,
connect the water hose to the pump inlet,
and run the product until the blockage is
removed. Reconnect the suction tube
afterwards and test.
• Keep the ventilation openings on the
motor clean and make sure they are not
blocked.
DISMANTLING AND STORAGE
1. Switch off the product and pull out the
plug.
2. Open the tap on the outlet tube and wait
until all the water has run out.
3. Empty the product by unscrewing the
drain plug underneath the pump.
4. Disconnect the suction tube and pressure
tube from the product.
5. Store the product frost-free (at least 5°C).
IMPORTANT:
Risk of material damage. All the seals should
be replaced if the product is dismantled.
Frost
Take the following measures if there is a risk
of frost. Undo the drain screw under the pump
outlet and allow all the water to run out
from the pump. If very low temperatures are
expected the pump should be disconnected,
emptied and then stored in a dry and frost-free
place.
IMPORTANT:
Risk of material damage. The product and its
accessories contain water, which means that
they can burst if the water freezes.
SERVICE AND REPAIRS
The product must only be serviced by qualified
personnel using identical spare parts. This will
ensure that the machine remains safe to use.
TROUBLESHOOTING
The troubleshooting guide on the next page
is used to identify the causes of common
problems and how they can be rectified.
Contact the dealer if the problem can not be
rectified with the help of the troubleshooting
chart. The warranty does not cover damage
resulting from repairs or attempted repairs
carried out by unauthorised persons.
WARNING!
Risk of personal injury. Repairs that are not
carried out correctly can result in the risk
of fatal or serious personal injury and/or
material damage.
EN
37