Meec tools 015275 Mode D'emploi page 35

EXPLANATION OF DISPLAY
Suction in progress (self-priming in progress). The product is running and
Suction in progress
there is underpressure in the suction tube, but there is no flow in the outlet.
Pump off
Pump off (the product is switched off). To switch off the pump, press OK.
When Pump off is shown on the display, press OK again.
Pump on
Pump on (the product is running). To start the product, press OK. When
Pump on is shown on the display, press OK again.
Power on
Power on (mains voltage on). This message is shown when the product is
connected to the mains, but has not started.
Flow XXXX I/h
Flow ****l/h and Pressure ***bar. Flow and pressure are shown during
Pressure XX bar
normal operation.
Standby (pressure retaining mode). The product continues to run for 10 seconds
Standby
after the outlet valve is closed. The display shows that the product is in pressure
retaining mode. The product starts automatically when the pressure drops
below the start pressure if the outlet valve is opened.
No water inlet (dry running). This message is shown and the run dry
protection switches off the product when the product has run for
No water inlet
30 seconds with an open outlet valve without pumping any water through
the outlet.
Leakage warning and Unable to pressurize. This message is shown and the
Leakage warning
overflow protection switches off the product if there is a serious leak in the
Unable to pressurize
piping system.
Turn on pressure
Time set
Exit
OK
Menu Press OK and the up arrow (Menu) for at least 3 seconds to go to the
settings menu.
1.5 bar
The settings menu for Turn on pressure opens. Press the OK to go to start
pressure, and set the required start pressure with the arrow buttons.
The start pressure can be set between 1.2 and 2.2 bar.
– Turn on pressure
– Time set
– Exit
– OK
– Menu
EN
35