Additional Safety Rules For Mitre Saws; Electrical Safety - Haussmann SMS15A-10-DB Manuel D'utilisation

ADDITIONAL SAFETY RULES FOR MITRE SAWS

Electrical safety

grounding provides a path of least resistance
for electrical current to reduce the risk of elec-
tric shock. This tool is equipped with an electric
cord that has an equipment grounding con-
ductor and a grounding plug. The plug MUST
be plugged into a matching outlet that is
properly installed and grounded in accordance
with ALL local codes and ordinances.
the outlet, have the proper outlet installed by a
qualified electrician.
ding conductor can result in a risk of electric
shock. The conductor with the green insulation
(or without yellow stripes) is the grounding
conductor. If repair or replacement of the elec-
tric cord or plug is necessary, DO NOT connect
the equipment grounding conductor to a live
terminal.
personnel if you do not completely under-
stand the grounding instructions, or if you are
not sure the tool is properly grounded.
3-prong grounding type plug and 3-hole re-
ceptacles that accept the tool's plug as shown
in the diagram. Repair or replace damaged or
worn cords immediately.
CAUTION: in all cases, make certain the recep-
tacle in question is properly grounded. if you are
not sure, have a qualified electrician check the
receptacle.
carry the tool or to pull the plug from an outlet.
Keep the cord away from heat, oil, sharp edges
or moving parts. Replace damaged cords
immediately. Damaged cords increase the risk
of electric shock.
WARNING: this mitre saw is for indoor use only.
do not expose it to rain or use in damp locations.
Service
fied repair personnel. Service or maintenance
performed by unqualified personnel could
result in a risk of injury.
-
Maintenance section of this manual. Use of
unauthorized parts or failure to follow Mainte-
nance Instructions may create a risk of electric
shock or injury.
Additional safety rules for
mitre saws
place.
saw.
saw.
Only use sharp blades.
prevent the workpiece from turning on both
sides of the blade.
or waste close by the saw blade.
manufacturer.
speed steel.
-
EN
23