Haussmann SMS15A-10-DB Manuel D'utilisation page 24

ADDITIONAL SAFETY RULES FOR MITRE SAWS
• If the table insert is damaged or worn, have it
replaced by an authorized service centre.
• Before making compound mitre cuts, ensure
that the work head is securely fixed in the
desired position.
• Rags, cloths, cord, string and the like should
never be left around the work area.
• Avoid cutting nails. Inspect the workpiece and
remove all nails and other foreign objects
before starting sawing.
• Support the work properly.
• Never reach over the blade to remove waste or
off cuts.
• Do not attempt to free a jammed blade before
first switching off the saw.
• Do not slow or stop a blade with a piece of
wood. Let the blade come to rest naturally.
• If you are interrupted when operating the saw,
complete the process and switch off before
looking up.
• Periodically check that all nuts, bolts and other
fixings are properly tightened.
• Always hold the saw on parts that are insulated.
If you accidentally cut into hidden wiring or
the saw's own cable, the metal parts of the saw
will become 'live' . Switch off at the mains and
remove the plug immediately.
• Connect the saw to a dust collection device
and ensure that it is operated properly.
• Wear gloves when handling saw blades.
well maintained and free of loose materials
such as wood chips and cut-offs.
• During slide cutting, always ensure that the
saw blade is pushed away from the operator.
• Always use stands to provide support for long
work pieces that overhang the turntable.
EN
• Feed work into a blade or cutter against the
direction of rotation of the blade or cutter only.
24
WEAR GOGGLES
WEAR EARMUFFS
WEAR A BREATHING MASK
WARNING! For your own safety read instruction
manual before operating mitre saw.Wear eye
protection. Keep hands out of path of saw blade.
Do not operate saw without guards in place.
Do not perform any operation freehand. Never
reach around saw blade.Turn off tool and wait
for saw blade to stop before moving workpiece
or changing settings.When changing the blade,
replace and secure all guarding to its original
position and correctly before starting tool. Dis-
connect power (unplug tool) before changing
blade or servicing. Do not expose to rain or use
in damp locations.To reduce the risk of injury,
return carriage to the full rear position after each
crosscut operation.
The tool must be used only for its prescribed
purpose. Any use other than those mentioned in
this Manual will be considered a case of misuse.
The user and not the manufacturer shall be
liable for any damage or injury resulting from
such cases of misuse.
The manufacturer shall not be liable for any
changes made to the tool nor for any damage
resulting from such changes.
Even when the tool is used as prescribed it is not
possible to eliminate all residual risk factors.The
following hazards may arise in connection with
the tool's construction and design:
• Damage to the lungs if an effective dust mask
is not worn.
• Damage to hearing if effective earmuffs are not
worn.