Bench Mounting - Haussmann SMS15A-10-DB Manuel D'utilisation

OPERATING INSTRUCTIONS
Accessories
The tool is supplied with the following accesso-
ries:
• Workpiece clamp
• 6 mm Hex key
• 2 Side bars
• Stabiliser Bar
• Dust bag
• Instruction manual
We recommend that you purchase your accesso-
ries in the store from where you obtained the
tool. Use good quality accessories from the
brand recommended by the vendor. Sales staff
will help and offer advice.
Unpacking
Due to modern mass production techniques, it
is unlikely that your HAUSSMANN Power Tool
is faulty or that a part is missing. If you find
anything wrong, do not operate the tool until
the parts have been replaced or the fault has
serious personal injury.
1) Remove all loose parts from the carton.
2) Remove the packing materials from around
the saw.
3) Using the carrying handle (8) carefully lift the
saw from the carton and place it on a level
work surface.
4) The saw has been shipped with the saw arm
locked in the down position.To release the
saw arm, push down on the top of the saw
arm, pull on the release knob (6), rotate it 45°
and let go, slowly raise the saw arm.
WARNING. Do not lift the saw while holding on
EN to the guards. Use the carrying handle (8).
Transportation
Lift the mitre saw only when the saw arm is
locked in the down position, the saw is switched
off and the plug is removed from the power point.
26
Only lift the saw by the carrying handle (8) or
outer castings. Do not lift the saw using the
guard or operating handle (7).

Bench mounting

The saw base has holes in each corner to facilita-
te bench mounting.
1) Mount the saw to a level, horizontal bench or
work table and fix the saw to the bench using
4 bolts (not supplied).
2) If desired, you can mount the saw to a piece of
13mm or thicker plywood which can then be
clamped to your work support or moved to
other job sites and re-clamped.
CAUTION. Make sure that the mounting surface
is not warped as an uneven surface can cause
binding and inaccurate sawing.
Stabilizer bar
When the saw is not fitted to a bench, always fit
the stabilizer bar (39) into the holes at the rear
of the saw base.The stabilizer helps prevent
the saw from tipping backwards when the slide
action is used.
Release knob
The release knob (6) is provided for holding the
cutting head down while transporting or storing
the mitre saw.The saw must never be used with
the release knob locking the head down.
Slide lock
When tightened, the slide lock (29) prevents the
saw head from sliding.Tighten the slide lock
during transportation.
Mitre table lock
The mitre table lock (25) is used to lock the table
at the desired mitre angle.
The mitre saw cuts from 0° to 45° both left and
right.To adjust the mitre angle loosen the mitre
table lock (25), press the locking button (25A)
and using the mitre table handle adjust the
mitre angle to the desired position.The mitre
table features positive click stops at 0°, 15°, 22.5°,
30° and 45° for quick setting of common mitre
angles.