Additional Safety Warnings - Haussmann M1Q-DU12-80 Guide De L'utilisateur

additiOnal saFetY warnings

1. Hold tool by insulated gripping surfaces when performing an
operation where the cutting tool may contact hidden wiring or its
own cord. Contact with a "live" wire will make exposed metal parts of
the tool "live" and shock the operator.
2. use clamps or other practical way to secure and support the
workpiece on a stable platform. Holding the work by hand or against
your body is unstable and may lead to loss of control.
3. do not drill, fasten or break into existing walls or other
blind areas where electrical wiring may exist. If this situation is
unavoidable, disconnect all fuses or circuit breakers feeding this
worksite.
4. never leave the trigger locked "On". Before plugging the tool in,
check that the trigger lock is "OFF". Accidental start-ups could cause
injury.
5. Be aware of the location and setting of the switch "lock-
On" button. If the switch is locked "ON" during the use, be ready for
emergency situations to switch it "OFF", by first pulling the trigger then
immediately releasing it without pressing the "Lock-ON" button
6. Keep hands away from cutting area. do not reach under the
material being cut. The proximity of the blade to your hand is hidden
from your sight.
7. Keep hands away from between the gear housing and saw blade
holder. The reciprocating blade holder can pinch your fingers.
8. do not use dull or damaged blades. Bent blade can break easily or
cause kickback.
9. Before starting to cut, turn tool "On" and allow the blade to
reach full speed. Tool can chatter or vibrate if blade speed is too slow
at beginning of cut; a kickback may also occur.
10. always wear safety goggles or eye protection when using this
tool. Use a dust mask or respirator for applications which generate dust
11. secure material before cutting. never hold it in your hand or
across your legs. Small or thin material may flex or vibrate with the
blade, causing loss of control.
12. make certain all adjusting screws and the blade holder are tight
before making a cut. Loose adjusting screws and holders can cause
the tool or blade to slip and loss of control may result.
5