Resistance Measurements - Klein Tools CL110 Manuel D'instructions

ENGLISH

RESISTANCE MEASUREMENTS

1. Insert RED test lead into V jack
jack , and rotate function selector switch
4
setting. The resistance symbol will appear on the display.
2. Remove power from circuit.
3. Measure resistance by connecting test leads to circuit. The
meter will auto-range to display the measurement in the most
appropriate range.
Black lead
NOTE: When in a Resistance setting and the test leads are open
(not connected across a resistor), or when a failed resistor is under
test, the display will indicate O.L. This is normal.
DO NOT attempt to measure resistance on a live circuit.
CONTINUITY
1. Insert RED test lead into V jack
jack , and rotate function selector switch
4
setting.
2. Remove power from circuit.
3. Test for continuity by connecting conductor or circuit with test
leads. If resistance is measured less than 10Ω, an audible signal
will sound and display will show a resistance value indicating
continuity. If circuit is open, display will show "OL".
Black lead
DO NOT attempt to measure continuity on a live circuit.
10
OPERATING INSTRUCTIONS
Red lead
Red lead
, and BLACK test lead into COM
5
to the Resistance
2
and BLACK test lead into COM
5
to the Continuity
2