Resistance Measurements - Klein Tools CL900 Manuel D'utilisation

ENGLISH
CONTINUITY
1. Insert RED test lead into VΩ jack
COM jack
4
Continuity/Resistance/Diode-Test
Black lead Red lead
NOTE: The meter defaults to Continuity testing in this setting.
Ensure that the Continuity Testing icon
If not, press the "SEL/DC ZERO" button
icon is shown.
2. Remove power from circuit.
3. Test for continuity by connecting conductor or circuit with test
leads. If resistance is measured less than 50Ω, an audible signal
will sound and display will show a resistance value indicating
continuity. If circuit is open, display will show "OL".
DO NOT attempt to measure continuity on a live circuit.

RESISTANCE MEASUREMENTS

1. Insert RED test lead into VΩ jack
COM jack
4
Continuity/Resistance/Diode-Test
Black lead Red lead
NOTE: The meter defaults to Continuity testing in this mode. Press
the SEL/DC ZERO" button
mode. The Resistance icon will appear on the display.
2. Remove power from circuit.
3. Measure resistance by connecting test leads to circuit. The
meter will auto-range to display the measurement in the most
appropriate range.
NOTE: When in a Resistance setting and the test leads are open
(not connected across a resistor), or when a failed resistor is under
test, the display will indicate O.L. This is normal.
DO NOT attempt to measure resistance on a live circuit.
12
OPERATING INSTRUCTIONS
, and rotate function selector switch
, and rotate function selector switch
once to enter Resistance testing
9
, and BLACK test lead into
5
setting.
is visible on the display.
repeatedly until the
9
, and BLACK test lead into
5
setting.
to the
2
to the
2